Detailed introduction to the installation of wire rope electric hoist
The wire rope electric hoist is a kind of easy-to-use hoisting machinery. Most of it is assembled and tested after the whole machine leaves the factory. Generally, do not disassemble and wash it during installation. The specific installation method and precautions are as follows:
Unpacking inspection: Check whether the factory technical data of the equipment is complete, and then whether the spare parts are matched and complete. Check whether the equipment is damaged. The steel wire ropes in the drum should be arranged neatly and should not touch the shell. Move the rotating parts by hand without jamming, loosening and abnormal noise.
Preparation before hoisting: scrub the oil stains on the body and add lubricating oil. According to the equipment delivery technical documents, check whether the I-beam model is compatible with the equipment. Disassemble the small wheel on the other side of the walking motor.
Hoisting and adjustment: tie the body with steel wire ropes, and pad the binding place with flexible materials such as rags or rubber sheets to avoid scratching the body. Use a 3-5t chain hoist to hang on the I-beam to hoist the machine body. If the hoisting is not in place, you can padded the I-beam with other steel to increase the hoisting point, or use a car hoist, tripod or other equipment to hoist, and install the small wheel on the other side of the motor after in place, according to GB50278-98 The specification requires that the gap between the inner side of the wheel flange of the electric hoist and the flange of the I-beam track should be adjusted to 3-5mm.
